- Emerson Remote Terminal Unit Instruction Manual

E-8 / Appendix E - Display/5x5Keypad CI-ControlWave Express
The current time is shown in the form of hours:minutes:seconds.
Figure 8 - Clock Display
E4.1.3.1 Changing the Time
From the display shown in Figure 8, press Time [F2]. Colons (:) will appear on the third
line. Enter the new time there and press [ENTER]. Valid times range from 00:00:00 to
23:59:59. Invalid entries will be ignored. The display will be updated to show the new time.
Figure 9 - Time Set Display
If you make a mistake while entering the new time, use [DEL] to backspace and delete one
character at a time.
E4.1.3.2 Changing the Date
From the clock display (Figure 8, press [F1]. Slash marks (/) will appear on the third line.
Enter the new date there and press [ENTER].
Figure 10 - Date Set Display
If you make a mistake while entering the new date, use [DEL] to back space and delete one
character at a time. Press [F4] to return to the Logged-On Display (Figure 7C).
Click here to return to Table of Contents