- Emerson Remote Terminal Unit Instruction Manual

CI-ControlWave Express Appendix C - Hardware Installation Guide / C-1
Appendix C
HARDWARE INSTALLATION GUIDE
Hardware Configuration
There are seven (7) main steps required to configure a ControlWave Express. This appendix
provides an overview of these steps with an emphasis on the installation and configuration
of the hardware. This appendix is intended for users who have already installed at least one
ControlWave Express.
Figure C-1 - ControlWave Express - Component Identification Diagram
Step 1. Hardware Configuration
This involves unpacking the ControlWave Express hardware, mounting the enclosure,
wiring I/O terminations, connecting any permanent communication cables, making proper
ground connections, connecting a communications cable to a PC workstation, setting
switches and setting jumpers. To install and configure the ControlWave Express, follow the
steps below:
1. Remove the unit from its carton and install it onto a panel or DIN-Rail in an
appropriate enclosure and then ultimately at the assigned work site (see Section 2.3.1).
Dimensions are provided in Section 4.6 of this manual.
Click here to return to Table of Contents