User's Manual

1. Remove the fan motor and housing assembly from
the styrofoam packaging and position it so that the
top of the motor is facing you.
2. Remove the hanger ball from the downrod by
loosening the setscrew in the hanger ball until the
ball falls freely down the downrod (Figure 1).
Remove the pin from the downrod, then remove
the hanger ball. Retain the pin and hanger ball for
reinstallation in step 8.
3. Separate, untwist and unkink the three motor leads.
Route the motor leads through the downrod and
seat the downrod in the motor coupling (Figure 2).
4. Align the clevis pin holes in the downrod with the
holes in the motor coupling. Install the clevis pin
and secure with the hairpin clip (Figure 2). (Pin and
clip are supplied in loose parts bag.) The clevis pin
must go through the holes in the motor coupling
and the holes in the downrod. Push the straight leg
of the hairpin clip through the hole near the end of
the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip
must be properly installed to prevent the clevis pin
from working loose. Pull the downrod to make sure
the clevis pin is properly installed.
5. Install the setscrew (supplied) in the motor coupling
(Figure 2). While pulling up on the downrod, tighten
the setscrew using the setscrew wrench (supplied).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
6. Slide the switch housing cover over the downrod
and position the cover onto the upper housing.
Install the three #8-32 x 10mm pan head screws
(supplied) (Figure 3).
7. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 4).
8. Reinstall the hanger ball on the downrod (Figure 4)
as follows. Route the motor leads through the
hanger ball and slide the hanger ball over the
downrod. Install the pin through the holes at the top
of the downrod and slide the hanger ball up the
downrod, aligning the ball so the pin in captured in
the groove in the top of the hanger ball. Pull the
hanger ball up tight against the pin and securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble.
4
How to Put Your Ceiling Fan Together
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 1
DOWNROD
#8-32 x 10mm PAN
HEAD SCREWS (3)
SWITCH
HOUSING COVER
Figure 3
Figure 2
SETSCREW
DOWNROD
PIN
HANGER BALL
CEILING COVER
Figure 4
HAIRPIN
CLIP
MOTOR
COUPLING
HAIRPIN
CLIP
SETSCREW
CLEVIS PIN
CLEVIS
PIN
DOWNROD
MOTOR
COUPLING
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew is securely
tightened. Failure to verify that the pin and setscrew
are properly installed (as shown in Figure 2) could
result in the fan falling.
WARNING
U.L. Model No.: CF3000