User's Manual
Page 81
J-400 Series
sequentially by selecting the next band and continuing the operation
during auto programming.
3.
Press TUN up/down button (2) once to activate manual tuning
mode, then press TUN up or down repeatedly to manually increase
or decrease displayed frequency. Press and hold either TUN up or
down button (2) for at least 2 seconds to activate auto tuning mode.
The unit will automatically search and stop at the next higher or
lower station with sufcient signal strength.
Note: After 3 seconds, seek mode is re-enabled.
4. Preset Scan Function
Press AS/PS button (6) once to enter scan mode. Each preset •
station in the current band will play for 5 seconds while the
preset number is ashes on the display (17). At the desired
station, press AS/PS button (6) a second time.
Press and hold ENT/SH button (5) until display reads “SHIFT”. •
Repeatedly press TUN up or down button (2) to choose preset
1-6, then press ENT/SH button (9) to conrm selection.
18.4 J-1000™ Audio System CD Player Operation
1.
Open front panel (16) by pressing rmly on release button (15) and
lifting panel upward from bottom edge. Gently insert CD into slot (14)
with label facing up. The CD will be drawn inside by the motorized
mechanism. DO NOT FORCE! Close front panel by folding down,
then press rmly on panel directly above release latch (15) until you
hear an audible “click”. Keep front panel closed at all the times to
prevent water intrusion, except when changing discs. CD playback
will automatically begin after CD is loaded.
To Play CD: Press the MODE button (4) to change to CD mode. •
The CD will play. The display shows current track, play time, and
animates a 3-D rotating disc during playback.
To Remove CD: Open the front panel and press CD eject button •
(13). Remove CD from drive and close front panel as instructed
in step 13 (page 7).