User's Manual

Page 80
J-400 Series
12. Adjusting Area
In FM2 band, press and hold the EQ
button (5) for about 2 seconds, then
repeatedly press until display reads
“USA” or “EUR”. Press VOL Up/Down
button (3) to choose desired setting,
then press and hold the BAND button
(8) for 2 seconds to conrm selection.
Note: Unit returns to volume mode if
volume control is not operated for 3
seconds.
13. 
Press rmly on the release button (15), then open front panel (16) by
gently lifting upward on bottom edge. To close front panel, gently ip
panel down, then press rmly on panel directly above release button
(15) until you hear an audible “click”. Keep front panel closed at all
the times to prevent water intrusion, except when changing discs.
CAUTION: Never insert wet discs into unit or CD player will be
damage!
18.3 J-1000™ Audio System Radio Operation
1. Radio Operation.
Press MODE button (4) to select Radio mode. Station frequency is
indicated on display.
To Select Band: Press BAND button (8) repeatedly to scroll
through radio mode as follows: FM1 --> FM2 --> FM3 --> AM1
--> AM2 -->FM1. Each radio band stores up to 6 independent
stations, for a total of 18 FM and 12 AM presets.
To Program Station Presets in Radio mode: Press and hold SH
button (5) until display reads “SHIFT”. Press and hold the Tune
up/down button (2) for 2 seconds, then repeatedly press to select
preset 1 to 6. At desired preset, press the ENT button (5) to store
current frequency into selected preset.
Note: When power to spa is shut off for any reason, all station presets
are reset.
2. Automatically Setting Station Presets
Press and hold the AS/PS button (6) for approximately 2 seconds
until you hear a beep that conrms the memory function is engaged.
The unit will search for six strong stations and automatically store
them on the current band. All 18 FM and 12 AM presets can be set
1
2
17
3
98
75
46
10
11
13
15
12
16
14