User's Manual

Page 11
J-400 Series
7. Select the power supply entrance you want to use (Figure A) and
remove the short cabinet panel from the front of the spa. Then, feed
the cable through the large opening provided in the bottom of the
control box.
8. Connect wires to the Green terminal block (Figure B-E, pages
12-13). ALL WIRES MUST BE SECURELY CONNECTED or
equipment damage could result!
9. Install control access box door and reinstall the cabinet side panels.
Figure A
Equipment Area
10
4
2
2
Flow
Note: Pump Locations Vary by Model
5
6
6
9
8
7
6
3
1
11
Access Door
1. J-1000™ Control Box
2. Power Supply Entrance(s)
3. Jet Pump #1
4. Heater
5. Spa Drain Valve
6. Pump Drain Plugs(s)
7. Jets Pump #2
8. Filter/Circulation Pump
9. Optional CD Ozonator
(Purchase Separately)
10. Factory Installed Ozone Injector
11. Control Panel