User's Manual
Page 9
J-400 Series
use considerable amounts of moisture will escape, potentially
causing mold and mildew over time which can damage certain
surfaces and/or surroundings.
Sufcient Access:• In the unlikely event that you should ever
need to access or gain entry to any portion of the spa for
servicing, it is highly recommended that you plan your indoor
installation to provide full access to the entire spa.
Warranty:• Damage caused by not following these guidelines
or any improper installation not in accordance to local codes
or authorities is not covered under the spas warranty. Please
consult your local state or city building ordinances.
WARNING: In addition to maintenance of lters and water
chemistry, proper ventilation is recommended to reduce the
risk of exposure to viruses and bacteria that could be present
in the air or water. Consult a licensed architect or building
contractor to determine your specic needs if installing your
spa indoors.
4.0 General Electrical Safety Instructions
Your new Jacuzzi® spa is equipped with the J-1000™
system. It contains
the most advanced safety and self-protective equipment in the industry.
Nonetheless, this spa must be installed properly to ensure dependable
usage. Please contact your local Jacuzzi dealer or local building
department should you have any questions regarding your installation.
Proper grounding is extremely important. Jacuzzi spas are equipped with
a current collector system. A pressure wire connector is provided on the
surface of the control box, located inside the equipment door (Figure-B,
page 12) to permit connection of a bonding wire between this point and
any ground metal equipment, metal water pipe or conduit within 5 feet
(1.5m) of the spa, or copper clad grounding rod buried within 5 feet
(1.5m) of the spa. Bonding wire must be at least No. 8 AWG (8.4 mm²)
solid copper wire. This is a most important safety assurance feature.
Before installing your spa, check with your local building department to
ensure installation conforms to local building codes.