User Guide

1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Copier Guardian II Unit.
3. Plug the Copier Guardian II unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Copier Guardian II where monitoring lights can
be observed.
INSTALLATION OF TBF™
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Pigtail
Outlet
Copier Guardian
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
Installation for Protection for Telephone Line and Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE" on
the Copier Guardian II.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
Telephone Line Protection clamping voltage 250-350 vdc.
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Copier Guardian II.
2. Plug the provided network cable to the RJ45 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the network cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Copier Guardian II where monitoring lights can be observed.
NOTE: All Copier Guardian II
units come with security straps,
warning label to secure unit to
connected equipment.
STRAP FOR PIGTAIL
RECEPTACLE
SECURITY STRAP WITH
WARNING LABEL
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
The GREEN light confirms properly the connected equipment is fully protected. The RED light
indicates over voltage, improper ground connection or reversed power wires which needs to
be corrected. In an over voltage incident, power is disconnected to protect the connected
equipment. IMPORTANT: If the RED Light comes on, contact your electrician to inspect
and correct the outlet wiring in order to receive the maximum protection for your connected
equipment.
CONNECTED
EQUIPMENT