Owner`s manual

Spa Side Control

Panel DS-2

(continued)

Standard or Economy Mode

Press this pad to switch between modes. Economy mode only heats the water during filter

cycles. Standard mode maintains the desired set temperature at all times.

Filter Cycles

Your spa will automatically filter itself twice a day. The first filter cycle will start one minute after the spa

is powered up. The second filter cycle will begin twelve hours later. The blower will run for 30 seconds at

the start of the first cycle to clean out the air lines. The low-speed pump will run during filter cycles (unless

the high-speed pump is activated) and the heater will be on. The ozone generator (if installed) will run on

low pump demand. Filter cycle duration is programmed via the topside panel for 3, 6, 9 or 12 hours. To

program, press the "Warm" or "Cool" pad, then press the "Mode" pad. Press the "Warm" or "Cool" pad

again to select the duration of the twice-daily cycle. Press the "Mode" pad to program the heater to enable

or disable during filter cycles.

Cleanup Cycle

The low-speed pump turns on 20 minutes after the jets pad is pressed. The cleanup cycle runs for 2 hours.

Disabling Pumps

In times when you are entertaining or relaxing in the area of your spa, you can turn off the pump to avoid

hearing any spa operational noise due to filtering or ozonating. To do this press the "Warm" or "Cool" pad,

then the "Light" pad, and all spa functions will be disabled except for freeze control. To resume spa opera-

tion, press any panel button.

Center Display Messages

These are some of the messages you may see on the center display.

Standard

The spa is in standard mode. StAN is flashed alternately with the current spa temperature

and COOL until the spa water is 20

F cooler than the set temperature.

Economy

The spa is in economy mode. ECON is flashed alternately with the current spa temperature

and COOL until the spa water is 20

F cooler than the set temperature.

Features and Controls