Owner`s manual

MAINTAINING YOUR SPA cont...

REMOVING, INSTALLING AND CLEANING FILTERS

These are the steps needed to successfully replace your lters.

You should replace your disposable spa lters and clean your

nondisposable lters every four months.

1) Turn off all power to your spa and remove

the lter lid by lifting it out towards you.

2) Turn the lter counterclockwise and

remove it from the lter well.

3) Dispose of the used lter.

5) To replace, set screen back into its

place and turn clockwise to fasten. DO NOT

over-tighten.

6) Place the new lter into position and turn

clockwise to fasten. DO NOT over-tighten.

7) Follow the directions 1) and 2) for the

pleated lter cartridge. You then rinse the

lter with a garden hose and soak the lter

in a mixture of one pint of lter cleaner

with 2.5 gallons of water for at least

12 hours. The lter must be completely

submerged. You then follow the directions

5) and 6) to replace the lter

WARNING: Power to your spa must be turned off prior to

removing your lters. The suction at the lter is extremely strong

and can cause injury if there is no lter. NEVER run your spa

without the lters properly installed. Injury to person and damage

to the equipment can occur. Any damage to equipment due to this

circumstance will not be covered under warranty.