Owner`s manual

27
Setting Filter cycle start
time
To program the lter cycle, you
must enter these parameters:
start time, duration and
frequency. During a lter cycle,
pumps run for one minute to
purge the plumbing,
then CP runs for the
programmed number of hours
and the ozonator is activated.
Press Ok key a second time.
The display will show FSxx, with
"xx" representing the starting
hour.
Use (+) or (-) key to change
setting (01:00- 12:00 AM/PM).
Setting Filter cycle
duration
Setting of the Filter cycle
duration in hours. If no
ltering is required, the
duration should be set to “0”.
Press Ok key a third time.
The display will show Fdxx,
with "xx" representing the
duration in hours.
Use (+) or (-) key to change
setting (00:00-23:00 hrs).
Filter cycle frequency
Press Ok key a fourth time.
The display will show FFxx,
with "xx" representing the
number of lter cycles per
day (up to 24 depending on
selected duration).
Use (+) or (-) key to change
setting.