Owner`s manual

22
Emerald Spa Owner's Manual
Spa Side Control
SC-3
for EMERALD CLASSIC
& EMERALD SE Series
[continued]
Setting water temperature:
Use Up or Down arrow key to regulate water temperature. To increase (decrease) current temperature
setting hold keypad until desired setting. When keypad is released and pressed again the setting will
decrease (increase) the temperature. The temperature setting will be displayed for 5 seconds to confirm
your new selection.
The "Set Point" indicator displays the desired temperature, NOT the current water temperature!
Water temperature can be adjusted by 1° increments from 59 to 104°F (15 to 40°C).
Automatic water heater start:
When water temperature is 1°F (0.5°C) lower than the Set Point, the heater will automatically turn on
until water temperature reaches Set Point plus 1°F (0.5°C).
The "Heater" indicator lights up when the heater is on.
Programming the filter cycle duration:
The system automatically performs two filter cycles per day, at 12-hour intervals. During a filter cycle, pump is
activated for a programmed number of hours. To set the filter cycle duration:
Press and hold Light key for
5 seconds. The display will show
a value that represents the filter
cycle duration in hours.
Use Up or Down arrow key to
change setting.
0 = no filtration
12 = continuous filtration
When the desired setting is displayed,
press Light key again. The filter cycle will
start. The "Filter" indicator lights up when
a filter cycle is on.