Please read this manual carefully before using. Specifications and design are subject to change without notice.
Contents Names of the parts Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Select the wash time Finish washing Disposal after washing Trouble-shooting Packing list *Specification
Names of the parts Timer knob Control panel Water inlet Filter cap Lint filter(Installed by user) Panel support Top lid Pulsator Cabinet Drain hose Base Fixing leg (four pieces) Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the personal safety of the user.
Safety precautions Please insert the power cord into special receptacle with rated voltage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is normally using, please put the power plug at the location easily to be inserted and extracted by hand. Be sure to pull the plug off when there's power failure, or the machine is being moved, cleaned or when it is idle.
Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not decompose, repair or alter the machine by yourself. Do not wash laundries with volatile materials (such as thinner, petrol etc.). l Petro Handicapped or children without care shall not use the machine.
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose When washing,the drain hose must be hung up,if you want to drain, please refer to the below mention. The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage. <10cm 2.
Adjust the installation position The largest permitted slope of the bearing surface of the washing machine is 2. Slanting or uneven ground will cause unstable operation of the machine. Please check with following methods: Hang a becket with weight to confirm if the washing machine is horizontal. Install the water inlet hose ; Select the water level Insert the water inlet hose into the water inlet jointer on the control panel.
Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Hang the drain hose up. Pay attention to followings before washing the laundries Check if the laundries has special requirement on washing Clear the Tie the long pocket. Take strips; fasten out the coins, the buttons; sand, hairpins close zippers.
The musts in washing The capacity of washing of the machinerefer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness ,size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonable amount of laundries and the laundries can be turnedround in washing for one time washing.
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and lint frame in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (See to Figure 1) Figure 1 2.
Packing list Quantity Name User's manual One piece Warranty card One piece Water inlet hose One piece Lint filter One piece Mini Washing Machine One set Specification Water level/Water quantity (about) 1/7L 2/12L 3/18L Injection pressure(MPa) 0.02 Rated washing capacity(kg) 0.2 2.
