User manual

Locating Beeper Operating Instructions Version 1.0
Page 6 of 20
• PRO-version with autarky supply due to integrated battery
• Sounding of alarm occurs caused by missing or erroneous
servo signal, a defined failsafe signal or interruption of the
supply (PRO-version)
• Simple deactivation (switching channel at transmitter)
immediately before turning the receiver off inhibits unwanted
alarm (PRO-version)
ATTENTION:
The Locating Beeper has two loudspeakers which generate a very high sound
pressure (high loudness). Under no circumstances hold the Locating Beeper
during operation close to or into the ear! This can lead to permanent damage of
the sense of hearing.
2. Mounting
Delivery of the Locating Beeper includes a tube clamp. This clamp is
simply mounted onto a board inside the models fuselage. The Locating
Beeper is pressed into the clamp and is therefore fixed. If necessary an
O-ring or some rubber band can be used additionally in order to secure
the clamp ends. Of course any other mounting method (e.g. silicone or
hot melt adhesive) is possible.
In order to allow for good sound opening select a position inside the
model where the sound opening is not covered or disabled.
The connection cable connects to a free, failsafe capable receiver
channel in order to utilize all features of the Locating Beeper.