User manual

DPSI RV Family Operating Instructions Version 2.1
page 34 of 44
6.11. Connecting Additional Products
Operation of the DPSI RV with gyroscopes
It is also possible to operate the DPSI using gyroscopes. In this case,
you must ensure that the servo(s) is / are not attached to the
gyroscope, but directly to the DPSI. The gyroscope is connected to the
existing circuit directly between the DPSI and the receiver.
Example:
The gyroscope is to be connected to channels 2 and 5 of the receiver
(for the ailerons). For this purpose, the gyroscope is connected as
usual directly to the receiver (channels 2 and 5). The cables, that
otherwise lead from the DPSI to the receiver, are now attached to the
servo outputs
(plugs) of the gyroscope. The servos are contacted to
the DPSI following the usual procedure.
Varios, smoke pumps, retractable gear and other consumer loads
All other consumer loads can be connected directly to the DPSI like a
normal servo. With the DPSI 2001 RV, additional consumer loads can
also be contacted directly at the receiver if the slots (channels) in the
DPSI 2001 RV are not sufficient.
The DPSI 2001 RV allows for voltage outputs with unregulated battery
power in order to connect additional consumers. This voltage is also
switched by the electronically switches of the DPSI 2001 RV. Here,
loads of up to 5A can be easily connected (additionally to “normal”
loads) because there takes no power dissipation place. This is true for
e.g. smoke pumps (APS PowerSmoke600).
Servomatching (DPSI V-Match):
If adjustments of individual servos are necessary (direction of rotation,
center-point, end-position), the EMCOTEC DPSI V-Match is in order.
Here, 2 servos can be connected; one of them can be adjusted as
desired. Due to its high load capacity the DPSI V-Match can be directly
connected to a servo output of a DPSI system.