User manual

DPSI RV Family Operating Instructions Version 2.1
page 33 of 44
6.10. Connecting the Servos
 The DPSI 2001 RV distributes 10 receiver channels to a total of 26
servos (8 multiple V-cables “built in”).
 The DPSI RV distributes 12 receiver channels to a total of 32 servos
(8 multiple V-cables “built in”).
For this purpose, a distribution that enables a number of combinations
has been selected.
When using digital servos, mind good air ventilation for the heat sink.
Hint:
Depending on the number and power of servos being used the overall current
consumption of the system changes. The higher the overall current, the more
energy will be transformed into heat. The heat sink of the DPSI can therefore
become very hot. This is not a fault, but rather represents normal functioning.
Thus, sufficient heat dissipation must be provided for (clearance to neighboring
walls, such as fuselage sidewalls or the like; cooling air supply, if possible). It is
possible to install an additional heat sink.
Hint:
The assignment of the printed connections of the DPSI systems to the receiver is
to be understood as suggestions! The receiver channels can be connected to
arbitrary DPSI inputs. Thus, the receiver channel “1” can be put into DPSI input
“3”. Servo outputs 3 of the DPSI are then being driven by receiver channel “1”.
The assignment therefore is elective!