User manual

DPSI RV Family Operating Instructions Version 2.1
page 29 of 44
6.8. Setting the Voltage
The output voltage of the DPSI RV can be set in 4 steps for the
receiver as well as the servos. This is done using the provided jumper,
which – depending on the output voltage - is plugged to the coding
strip of the DPSI. It is best to use tweezers or a small pincer for this
purpose.
Setting the voltage for receiver and servos to 5.4 Volt (both jumpers in):
The positions of the jumpers for the corresponding output voltages are
printed onto the housing of the DPSI. Due to vibration less mounting of
the DPSI the jumpers can not slip out.
Hint:
The output voltage of the DPSI 2001 RV is fixed to 5.9 volts. Other voltages are
not possible.