User manual

DPSI RV Family Operating Instructions Version 2.1
page 24 of 44
Hint:
In the case that the system does not work properly, please check whether all
cables are plugged in correctly and if the type of modulation of the transmitter
corresponds to that of the receiver.
Hint:
The assignment of receiver channels according to the print image of the DPSI
housing is just a suggestion! In any case, the assignment can be arbitrary. This
means, receiver channel 1 must not necessarily be connected to channel 1 of the
DPSI. It is just important, that the corresponding servo outputs fit to the
corresponding receiver inputs at the DPSI (e.g. receiver input 2 to servo output
2). Therefore, receiver channel 1 can be connected to DPSI input 2. In this case,
servos at output 2 are driven by receiver channel 1.
Hint:
Under no circumstances connect a patch-cable from a servo output of the DPSI
to the receiver. The DPSI or the receiver could be damaged!