User manual

DPSI RV Family Operating Instructions Version 2.1
page 22 of 44
The central, ultra-bright light-emitting diode (LED) in the switch
transmitter always illuminates when the DPSI is switched on. In case of
an error (e.g. low voltage) or during programming the LED indicates
the states through different blink codes.
Two commercial battery controllers can be plugged directly to the
backside of the switch using JR Uni-Connectors. The inscription “B1”
stands for battery 1 and “B2” for battery 2. This enables additional
optical voltage monitoring of the batteries. When using this type of
battery controller, you must ensure that the required number of cells is
correctly set.
Hint:
When the DPSI is turned off, possibly connected battery controllers are turned off
also.
Magnetically Switch Actuator (Printed Circuit Board):
An especially light weight and space saving magnetically switch
actuator is available in PCB design.