User manual

DPSI RV Family Operating Instructions Version 2.1
page 20 of 44
The receiver set is turned on and off using a pin, which just delivers an
on / off signal. Putting the pin into the on-socket (red) turns the DPSI
on. Putting the pin into the off-socket (black) turns it off. The DPSI
stays turned on, even if the pin gets lost.
A DPSI only turns off by placing the pin into the off socket (i.e. moved)!
DPSI pin switch actuator:
Hint:
In the case of a lost pin, you can help yourself by using a 2 mm (0.08”) wire or
screw, which is simply put into the corresponding socket.
The On/Off switch transmitter can be placed wherever desired (e.g. on
a fuselage sidewall). The connection cable with plug is plugged into the
respective multiple plug of the DPSI until it locks into place on impact
(see photo page 21). In the event that replacement or removal is
necessary, the plug can be disengaged from the multiple plugs upward
by carefully pulling it out (take hold of the cable directly at the plug).