User manual

DPSI RV Family Operating Instructions Version 2.1
page 15 of 44
6. Installation Instructions and Programming
6.1. Installing the DPSI RV
The simplest method of installation is to glue the receiver directly to the
DPSI using double-sided adhesive cellular rubber strips (5-10 mm
thick). The receiver can also be attached separately; this is the
preferred method when using 2.4GHz receivers.
Hint:
The lower side of the DPSI where the heat sink resides, may not have anything
pasted on it and may not be covered up and should be at an interval of at least
30mm (1.2”) from the nearest surface (fuselage floor or similar)! Good ventilation
is required (such as with air scoops or conducted cooling air), especially if there
are numerous servos.
Since the DPSI is most often used in large models, it is advisable to
fasten the entire package with rubber bands on 4 sides, oscillating
freely in the fuselage (see photo).