User manual

6 of 14
EMCORE Broadband
2015 West Chestnut Street
A
lhambra, California 91803-1542
Tel: [phone]
Fax: [phone]
Copyright 2008. EMCORE Corporation
EOS 6000 Optical A/B Switch
USER MANUAL | SEPTEMBER 9, 2008
3. Inspect the appearance of the unit for any shipping damage.
4. In case of damage, document and inform the shipping company and your local representative.
5. Save the shipping boxes and their inserts for any future reshipment for upgrade or repair.
NOTE: In the event of a reshipment back to the manufacturer, any additional damage caused by not using the
original boxes will be considered the responsibility of the customer.
Optical Switch Mounting and Power Connection
1. Mount the unit into a 19-inch wide rack or cabinet.
2. Turn the unit power supply switch located on the rear panel off.
3. Connect wires DC+, DC-, and GND to the pluggable terminal block that is connected to the
DC input of the power supply. The DC power source must be 36 – 60VDC and wires used
must handle at least 10VA.
4. Turn the unit power switch to the ON position.