User manual

4 of 14
EMCORE Broadband
2015 West Chestnut Street
A
lhambra, California 91803-1542
Tel: [phone]
Fax: [phone]
Copyright 2008. EMCORE Corporation
EOS 6000 Optical A/B Switch
USER MANUAL | SEPTEMBER 9, 2008
Getting Started
Before Initializing and Operating the Unit
1. Inspect the optical switch for any signs of damage, and read the User’s Manual thoroughly.
2. Install the optical switch as specified in the Getting Started section.
3. Ensure that the optical switch and any devices or cords connected to it are properly grounded.
4. Become familiar with all safety symbols and instructions to ensure that the optical switch is operated
and maintained safely.
Initial Inspection
WARNING: To avoid electrical shock, do not initialize or operate the unit if it bears any sign of
damage to any portion of its exterior surface, such as the outer cover or panels.
Check that the unit and contents are complete:
1. Wear an anti-static wrist strap and work in an electrostatic discharge (ESD) controlled area.
2. Inspect the shipping container for any indication of excessive shock to the contents, and inspect the
contents to ensure that the shipment is complete.
3. Inspect the unit for structural damage that can have occurred during shipping.
Note: Keep the packaging.
Immediately inform Emcore and, if necessary, the carrier if the contents of the shipment are incomplete, if
the unit or any of its components are damaged or defective, or if the unit does not pass the initial
inspection.
WARNINGWARNING