User manual

3 of 14
EMCORE Broadband
2015 West Chestnut Street
A
lhambra, California 91803-1542
Tel: [phone]
Fax: [phone]
Copyright 2008. EMCORE Corporation
EOS 6000 Optical A/B Switch
USER MANUAL | SEPTEMBER 9, 2008
Safety Information
Power Requirements
The system operates from a DC power source that supplies -36 to -60 V DC.
Safety Instructions
The following safety instructions must be observed whenever the unit is operated, serviced, or repaired.
Failure to comply with any of these instructions or with any precaution or warning contained in the user’s
manual is in direct violation of the standards of design, manufacture, and intended use of the unit. Emcore
assumes no liability for the customer’s failure to comply with any of these safety requirements.
Before Initializing and Operating the Unit
 Inspect the unit for any signs of damage, and read the user’s manual thoroughly.
 Install the unit as specified in the Getting Started section.
 Ensure that the unit and any devices or cords connected to it are properly grounded.
Safety Symbols
The following symbols and messages can be marked on the unit (Table 1). Observe all safety
instructions that are associated with a symbol.
Table 1: Safety Symbols
Symbol Description
Laser safety. See the user’s manual for instructions on handling and operating the unit safely.
See the user’s manual for instructions on handling and operating the unit safely.
Electrostatic discharge (ESD). See the user’s manual for instructions on handling and operating the
unit safely.
Frame or chassis terminal for electrical grounding within the unit.
Protective conductor terminal for electrical grounding to the earth.
The procedure can result in serious injury or loss of life if not carried out in proper compliance
with all safety instructions. Ensure that all conditions necessary for safe handling and
operation are met before proceeding.
The procedure can result in serious damage to or destruction of the unit if not carried out in
compliance with all instructions for proper use. Ensure that all conditions necessary for safe handling
and operation are met before proceeding.
WARNINGWARNING
CAUTIONCAUTION