Installation Guide
7
6. INSTALL WEATHER SEALING COMPONENTS
2 - #8x1/2”
INTERIOR FLOOR
Tools needed:
1/8”
2
8
8
LEFT HINGE - INTERIOR VIEWS RIGHT HINGE - INTERIOR VIEWS
7. INSTALL CLOSER AND HANDLE SET
Refer to the instructions in the hardware kit box to install the closer and the handle set. Many home improvement stores or locksmiths can make 
duplicate keys.
1.
Figure 22
For doors with a Brass or Nickel nish 
sweep only: in this step, you will install 
the bottom sweep n (Figure 21).
Slide the sweep n into the n track 
ush with the sweep end.
Use pliers to crimp the ends of the 
track legs (both ends) to secure the 
n.
Trim off excess sweep n material. 
Open the door and slide the sweep 
onto the bottom of the door frame. 
Make sure that the screw slots on 
the sweep are towards the interior.
Position the door sweep so that it is 
ush with the latch-side of the door 
frame (Figure 22).
Close the door.
From the interior, adjust the sweep 
up or down until the sweep ns 
come into contact with the door sill.
Using the drill and 1/8” drill bit, drill 
a starter hole into the door using the 
pre-drilled hole slots as guides. 
Fasten the sweep to the door using 
two (2) or four (4) #8 X 1/2 color-
matched (to sweep) screws.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Do not drill completely through 
door. This will create an
unnecessary hole in the door 
and may cause water and air 
inltration.
CAUTION
In this step, you will install the sweep.
Figure 21
8
9
9
8. ADJUST THE CLOSER
Tools needed:
In this step, you will adjust the door closer. 
Locate the adjustment screw at the end of the 
closer that attaches to the door frame (Figure 
23).
Open the door and then let it close to note the 
speed at which the door closes.
Using a Phillips head screwdriver to adjust 
the closer to the desired speed: 
For a faster closing speed, turn 
the adjustment screw to the left 
(counterclockwise). 
For a slower closing speed, turn the 
adjustment screw to the right (clockwise).
Test the speed at which the door closes after 
each adjustment. Adjust the screw more, if 
needed, to achieve the desired door closing 
speed.
1.
2.
3.
4.
•
Figure 23
SLOWER
FASTER
9
8
9
2
8
8
4 - #8x1/2”
INTERIOR FLOOR
Figure 22
OR
Figure 21
•
RIGHT HINGE - INTERIOR VIEWS
LEFT HINGE - INTERIOR VIEWS
Figure 23
SLOWER
FASTER








