Installation Guide

3
In this step, you will remove the ventilating glass panels.
Lay the door at on a protected surface with the exterior side down.
TIP: Lay on door carton.
Remove the lower ventilating glass panel by pulling the latches
at the bottom toward each other. Lift the lower portion of the
ventilating glass panel up and then rotate it to remove (Figure 5).
Repeat the previous step to remove the upper ventilating glass
panel.
Stand each glass panel on its edge and out of the way to prevent
damaging them.
Remove the insect screen by pulling the two pins toward each
other, then pull the insect screen up. Rotate the insect screen out of
its track (Figure 6).
Stand the insect screen on its edge and out of the way to prevent
damaging to it.
Left-hinged door (Figure 7) - Looking at the door from the exterior, a
left hinged storm door will have the hinge rail on the left side of the
storm door. Refer to the illustrations in the column on the left side of
the installation guide under this heading:
Right-hinged door (Figure 8) - looking at the door from the exterior,
a right hinged storm door will have the hinge rail on the right side of
the storm door. Refer to the illustrations in the column on the right
side of the installation guide under this heading:
1.
2.
3.
4.
5.
6.
7.
8.
2. INSTALLATION PREPARATION
Figure 7
Figure 8
LEFT hINGE
RIGhT hINGE
EXTERIOR
VIEWS
Remember, any mis-cuts during your storm door installation can be
replaced free of charge. Just call our Solution Center at
1-800-933-3626.
Figure 5
Figure 6
In this step, you will remove the insect screen.
In this step, you will determine which side of the opening to use as the
hinge side.
LEFT hINGE
RIGhT hINGE