Installation Guide

5
LEFT hINGE - ExTERIOR VIEWS RIGhT hINGE - ExTERIOR VIEWS
6 - #8x1”
1/8”
Tools needed:
4. hANG hINGED STORM DOOR:
Figure 14
Figure 15
Figure 16
2
3
1
Figure 14
Figure 15
Figure 16
In this step, you will hang the storm
door in the opening.
Position the door in the opening so
that the edge of the hinge rail is ush
with the end of the rain cap, and the
top end of the hinge rail is butted up
against the underside of the rain cap
(Figure 14).
While holding door in position,
mark onto the mounting surface the
location of the top-most pre-drilled
hole in the hinge rail. Once marked,
remove door from opening and set
aside.
Using the 1/8” drill bit, drill a hole
in the mounting surface where you
placed the mark.
Reposition the door in the opening
and align the pre-drilled hole in the
hinge rail with the hole that you
drilled in the mounting surface.
Fasten the door to the mounting
surface using one (1) #8 x 1” painted
screw.
Using the level, make sure that the
door is plumb (straight up and down).
While holding door in position,
use the 1/8” drill bit to drill holes in
the mounting surface through the
pre-drilled holes in the hinge rail.
Fasten the hinge rail to the mounting
surface using ve (5) #8 x 1 painted
screws (Figure 15).
Open the storm door.
Using the 1/8” drill bit, drill holes in
the door jamb through the pre-drilled
holes in the hinge rail.
Fasten the hinge rail to the door
jamb using eight (8) #8 x 1 unpainted
screws (Figure 16). Do not
overtighten the screws
Now that the door is hanging, install
the insect screen and two ventilating
glass panels in the reverse order of
what was done in step 2. (Figures
5 & 6)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
8 - #8x1”
3
2
1
In this step, you will install the insect
screen and ventilating glass panels.