Instructions / Assembly

6
INSTALL
LATCH RAIL
(Left Hand)
5
1/8”
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
1”
x 3
x 6
Pad
1. Refer to the instructions included in the
Installation Kit to install the closer.
1. Find the three 1/2” square adhesive backed
spacer pads in yellow bag in installation kit.
2. Swing door open and wipe o any residue
on edge of door.
3. Peel paper backer o each pad and attach
them to latch side door edge. Position one
approximately 6” down from top of door,
another close to center of door, and the
third approximately 6” up from bottom.
1. Place latch rail (F) in the opening with top
end pushed up against rain cap.
2. Close storm door and slide latch rail
towards door frame until it contacts all
three spacer pads, creating 3/16” gap.
3. Using drill bit and 1” screws from yellow
bag, fasten latch rail to mounting surface.
4. Open storm door and remove spacer pads,
then properly discard.
Tools needed:
F
YELLOW BAG / bOLSA AMARILLA /
SAC JAUNE
Installation
Kit
Installation
Kit
1. Close the storm door.
2. From the interior, loosen the sweep screws
with a phillips screw driver. Adjust the
sweep (G/H) up or down until the sweep n
lightly comes into contact with the door sill.
3. Retighten the sweep screws.
L
L
G
H
F
a b
a
PAD
ALMOHADILLA
TAMPON
!
!
1/2” 1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
i
VIEW
X
VIEW
X
VIEW
BOTTOM
pARTE InfERIOR
BAS
1.
Refer to the instructions included in the
Installation Kit (L) to install the door handles.
INSTALL
HANDLE SET
(Left Hand)
INSTALL
CLOSER
(Left Hand)
ADjUST
SWEEP
(Left Hand)
(If necessary)
6
7 8
a
a
Tools needed:
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
L
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
i
VIEW