User manual

Slave Components - G-Modules (General Purpose)
Product Catalogue all information for reference only - technical changes reserved - rev. 9 Page 54 of 171
6.2.4.7 Process Data Image
Out-Userdata from Master to Slave
total: 1 Bytes
In-Userdata to Master from Slave
total: 0 Bytes
Byte
Function
rC Assign...
Byte
Function
rC Assign...
0
Relay Control
Bit 0 = single Relay 1
...
Bit 2 = single Relay 3
Bit 3 = activation of all 3 relay
... + eB_B0, 0, ...
...
... + eB_B0, 2, ...
... + eB_B0, 3, ...
none
Relay Control
-
-
-
-
AAR
REL3
REL2
REL1
Bit 7
Bit 0
Bit 3 ............................................ AAR: Activate all 3 Relays
1 = activate all Relays, regardless of REL
0 = Switch Relays according to REL1..3
Bit 2-0 ......................................... REL<3:1>: Relay control (if AAR = 0)
1 = activate corresponding Relay
0 = deactivate corresponding Relay
6.2.4.8 Programming Note
In Addition to the notes in chapter 4, please regard the following:
 The relays can each be activated individually by setting/resetting the Bit 0 ... 2 or all three
relays together by activating Bit 3. This is a logical OR operation.