User manual

Slave Components - G-Modules (General Purpose)
Product Catalogue all information for reference only - technical changes reserved - rev. 9 Page 52 of 171
6.2.4.3 Terminal Assignment
Circuit Example
Ident.
Ter.
Function
Usage
internal simplified diagram
CO1
1
Relay 1
(corner contacts
via AMP-plug)
change-over
CO1
2
NO1
3
normally-open
NO1
4
CO2
5
Relay 2
(corner contacts
via AMP-plug)
change-over
CO2
6
NO2
7
normally-open
NO2
8
CO3
9
Relay 3
(corner contacts
via AMP-plug)
change-over
CO3
10
NO3
11
normally-open
NO3
12
6.2.4.4 LED Indications
LED1..3 ..................................... status indication of the outputs relay 1..3
Status-LED .................................. module status (see 6.1.1)
6.2.4.5 Application Note
In Addition to the notes in chapter 4, please regard the following:
 All three relays have to operate on the same voltage level 230VAC or 24VAC or 24VDC. A
mixture of different voltage levels is not allowed.
 When using the module in 3 phase-operation, the electrical load must have a star point that
is connected to N of the supply. Driving a load with delta-connection is not allowed.
 The user must install an appropriate fuse in the supply line of the relays
 This module support relay contacts. Depending on the electrical application, the user has
to install sufficient additional components to fulfill the EMC-standads and the require-
ments of the relay producer (see relay datasheet), especially when driving induc-
tive/capacitive or high inrush current loads.
N
L1
L1
N
N
L1
M