User manual

Page | 82
The information in the HyperTerminal window is shown below;
eth0 Link encap:Ethernet HWaddr 00:11:22:33:44:55
inet addr:192.192.192.203 Bcast:192.192.192.255
Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:185 Base address:0x2000
2. Execute the following instruction to test the network
communication between the SBC8140 and the PC;
root@SBC8140:~# ping 192.192.192.170
The information in the HyperTerminal window is shown below;
Table 1-1 Testing Network
PING 192.192.192.170 (192.192.192.170): 56 data bytes
64 bytes from 192.192.192.170: seq=0 ttl=128 time=4.486 ms
64 bytes from 192.192.192.170: seq=1 ttl=128 time=0.336 ms
The above information indicates the network is working properly.
3.8.9 Testing the CameraCam8000-A
Connect the camera module (needs to be purchased separately), CCD
camera and LCD screen to the SBC8140, and then execute the following
instructions;
root@SBC8140:~# saMmapLoopback
The information in the HyperTerminal window is shown below;
tvp514x 2-005d: tvp5146m2 found at 0xba (OMAP I2C adapter)
Capture: Opened Channel
Capture: Current Input: COMPOSITE
Capture: Current standard: PAL
Capture: Capable of streaming