User manual

Page | 73
Texas Instruments X-Loader 1.47 (Mar 1 2013 - 17:05:22)
Starting X-loader on MMC
Reading boot sector
231872 Bytes Read from MMC
Starting OS Bootloader from MMC...
Starting OS Bootloader...
U-Boot 2010.06-rc1-svn84 (Mar 04 2013 - 12:00:27)
OMAP3630-GP ES2.1, CPU-OPP2 L3-133MHz
OMAP3 SBC8140 board + LPDDR/NAND
I2C: ready
DRAM: 256 MiB
NAND: 512 MiB
*** Warning - bad CRC or NAND, using default environment
In: serial
Out: serial
Err: serial
Die ID #3d1400029e3800000168682f07003018
Net: dm9000
Hit any key to stop autoboot: 0 (press any key to enter u-boot mode)
1. Configuring for a 4.3” LCD;
Execute the following instructions in u-boot mode to configure for 4.3”
display mode;
OMAP3 SBC8140 # setenv defaultdisplay lcd
OMAP3 SBC8140 # setenv dispmode 4.3inch_LCD
OMAP3 SBC8140 # saveenv
2. Configuring for a 7” LCD;
Execute the following instructions in u-boot mode to configure for 7”
display mode;
OMAP3 SBC8140 # setenv defaultdisplay lcd
OMAP3 SBC8140 # setenv dispmode 7inch_LCD
OMAP3 SBC8140 # saveenv