User manual

Page | 72
11648 bytes read
HW ECC selected
NAND write: device 0 offset 0x0, size 0x2d80
12288 bytes written: OK
reading flash-uboot.bin
231872 bytes read
SW ECC selected
NAND write: device 0 offset 0x80000, size 0x389c0
233472 bytes written: OK
reading uImage
2548700 bytes read
SW ECC selected
NAND write: device 0 offset 0x280000, size 0x26e3dc
2549760 bytes written: OK
reading ubi.img
12320768 bytes read
SW ECC selected
NAND write: device 0 offset 0x680000, size 0xbc0000
12320768 bytes written: OK
When the LEDs on the kit start to blink, the update is completed; please
remove the SD card and reboot the system;
3.7 Display Mode Configuration
The system supports multiple display modes. Users can select an
appropriate mode by configuring boot parameters. The following contents
show how to configure for both 4.3” and 7” LCDs, VGA mode and LVDS
mode.
You need to enter u-boot mode to complete these configurations. Please
reboot the kit and press any key on your PC’s keyboard when the system
prompts you with a countdown in seconds as shown below;