User manual

Page | 71
3. Insert the SD card into the SBC8140 and power it on; when the
information on the serial interface shows a countdown in
seconds, press any key on your PC’s keyboard to enter u-boot
mode;
Texas Instruments X-Loader 1.47 (Mar 1 2013 - 17:05:22)
Starting X-loader on MMC
Reading boot sector
231872 Bytes Read from MMC
Starting OS Bootloader from MMC...
Starting OS Bootloader...
U-Boot 2010.06-rc1-svn84 (Mar 04 2013 - 12:00:27)
OMAP3630-GP ES2.1, CPU-OPP2 L3-133MHz
OMAP3 SBC8140 board + LPDDR/NAND
I2C: ready
DRAM: 256 MiB
NAND: 512 MiB
*** Warning - bad CRC or NAND, using default environment
In: serial
Out: serial
Err: serial
Die ID #3d1400029e3800000168682f07003018
Net: dm9000
Hit any key to stop autoboot: 0 (press any key to enter u-boot
mode)
4. Type run updatesys and press the Enter key to start a system
update; the information on the serial interface is shown below;
OMAP3 SBC8140 # run updatesys
NAND erase: device 0 whole chip
Erasing at 0x1ffe0000 -- 100% complete.
OK
mmc1 is available
reading x-load.bin.ift_for_NAND