User manual

Page | 130
14. Type w to save new partition records as shown below;
Command (m for help): [ w ]
The partition table has been altered!
Calling ioctl() to re-read partition table.
WARNING: Re-reading the partition table failed with error 16:
Device or resource busy.
The kernel still uses the old table.
The new table will be used at the next reboot.
WARNING: If you have created or modified any DOS 6.x
partitions, please see the fdisk manual page for additional
information.
Syncing disks.
15. Execute the following instructions to form the new partitions;
$ [sudo mkfs.msdos -F 32 /dev/sdc1 -n LABEL1]
$ [sudo mkfs.ext3 -L LABEL2 /dev/sdc2]
Note:
 The drive labels LABEL1 and LABEL2 in the above instructions are just for
reference, you can use your own labels if required;
 After the FAT and EXT3 partitions are formatted, the FAT partition needs to be
formatted again under a Windows system to avoid failure when booting from
the TF card.