Specifications

Page | 13
The WinCE system is updated and booted up successfully after the booting
process is completed.
Note:
 By default the SBC8140 boots from NAND Flash; pressing and holding the
BOOT button before connecting the power can make it boot from the SD card.
4.2 Updating and Booting from NAND Flash
1. Please refer to the step 3.11 in section 3.1 to format an SD
card; After the SD card has been formatted, copy the files MLO,
EBOOTSD.nb0, EBOOTNAND.nb0, NK.bin and XLDRNAND.nb0
from X:\WINCE600\image\ (where X is the label of your DVD
drive) to the SD card, and then rename EBOOTNAND.nb0 to
EBOOTND.nb0.
2. Insert the SD card into the SBC8140, and then power it on while
pressing and holding the BOOT button; when you see the
terminal information counting down in seconds, press the
Space key to enter the eboot menu;
3. Type 8 in the eboot menu to enter the flash management
menu;
4. Type a, b and c to program the XLDR, EBOOT and the NK image
file into flash;
5. Type 0 to go back to main menu, and then type 2 and 4 to boot
from NAND Flash;
6. Type a in the main menu to select a display mode, and then
type 7 and y to save the changes;
7. Remove the SD card from the SBC8140 and reboot it; the
system will boot up from NAND Flash;