User manual

Page | 2
2 Introduction to the WinCE 6.0
system
2.1 Image files related to the SBC6300X
WinCE 6.0 system
If the WinCE system is customized using the SBC6300X WinCE 6.0 BSP
that we provide and the compilation is successfully finished, the system
will generate 6 image files, i.e.: FIRSTBOOT.nb0, EBOOT.nb0, NK.nb0,
FIRSTBOOT.bin, EBOOT.bin, NK.bin, of which 4 files are usually used in
burning processes, i.e.: FIRSTBOOT.nb0, EBOOT.nb0, NK.nb0, NK.bin. The files
generated in .nb0 format will finally be burnt to DataFlash or NAND Flash,
and they can directly run in SDRAM; while the files in .bin format must
first be converted into .nb0 files by EBOOT running on SBC6300X main
board nb0, they are then burnt to DataFlash or NAND Flash.
2.2 Working principles of the SBC6300X
WinCE 6.0 system
At present, our SBC6300X WinCE 6.0 BSP supports two booting modes,
i.e.: SPI DataFlash and NAND flash. Below is their rough booting flow
chart: