User manual

Page | 33
5 System Customization Based
on the WinCE 6.0 BSP
Note:
 To develop a Windows Embedded CE 6.0 operating system using the
SBC6300X BSP, you need setup a Windows Embedded CE 6.0 development
workstation. This Manual assumes that the Windows Embedded CE 6.0
development workstation software has been installed on Drive F, e.g. the
installation path for Windows Embedded CE 6.0 is [F:\WINCE600].
5.1 Installation of the WinCE 6.0 BSP
Unzip the archive located in: SBC6300X CD\03WinCE6.0Kit\01BSP\SBC6300X.rar to
the F:\WINCE600\PLATFORM folder of the development workstation. Unzip the
archive located in: SBC6300X CD\03WinCE6.0Kit\01BSP\ATMEL.rar to the
location: F:\WINCE600\PLATFORM\COMMON\SRC\SOC on the development
workstation. Once this is complete, the installation of SBC6300X WinCE
6.0BSP is finished.
Compilation of a WinCE system based on the SBC6300X WinCE 6.0 BSP
Here we will not describe how to customize a WinCE project based on the
BSP in a VS2005 WinCE 6.0 development environment, the user can
directly copy the SBC6300X CD\03WinCE6.0Kit\02Project\SBC6300X.rar archive to
the directory F:\WINCE600\OSDesigns\ on the development workstation, and
unzip this file into the same directory. The user can then directly open the
project file SBC6300X.sln (in the F:\WINCE600\OSDesigns\SBC6300X folder), and
select (Build-> Build Solution) in VS2005 to start compiling the
customized WinCE system.
Customisation of a WinCE system based on the SBC6300X WinCE 6.0 BSP
This section will describe how to customize WinCE 6.0 in the SBC6300X
BSP:
1. Open Visual Studio 2005 and click File->New->Project, as
below: