User manual

Page | 8
with the default path and configuration of the program. After the
installation is complete, you will see the SAM-BA v2.8 icon on the
desktop:
Figure 4: SAM_BA Icon
3.2.2 Burning a system image using SAM-BA software
1. Make sure the three-way DIP switch is set to the OFF state and
make sure there is no SD card in the SD slot of the SBC6300X.
2. Connect the USB device port (J9) of the SBC6300X to the USB
Host of the development workstation using the supplied USB
cable.
3. Connect the supplied 12V power supply to the J1 port of the
SBC6300X main board.
4. Turn on the power switch (SWITCH B1) of the SBC6300X main
board; the SBC6300X main board should now be energized.
5. Double click the SAM-BA v2.8 icon as shown below to run the
SAM-BA v2.8 program, and select AT91SAM9263-EK and
\usb\ARM0 from the menu as shown below.
Figure 5: SAM-BA Initialisation
6. Click the Connect button to enter the interface as shown below.