User manual

Page | 7
3 Burning a WinCE System
3.1 Introduction to Burning System Image
Files
The SBC6300X WinCE 6.0 BSP supports two burning modes:
1. Burn FIRSTBOOT, EBOOT and WinCE system image NK using
the SAM-BA software provided by ATMEL;
2. Connect VS2005 WinCE 6.0 development environment installed
on client development workstation or other TFTP servers (e.g.:
CEDownload.exe) to the SBC6300X main board, burn WinCE
system image files NK via net cable using EBOOT on the
SBC6300X (the EBOOT on the SBC6300X WinCE 6.0 BSP
doesn’t support the burning of user booting codes FIRSTBOOT
and EBOOT, it can only burn the WinCE system image file
NK.bin).
Note:
 If you use EBOOT as the user booting code on the SBC6300X main board to
WinCE system image file NK, the actual process will be, EBOOT, the user
booting code on SBC6300X main board will first download WinCE system
image file NK.bin that VS2005 WinCE 6.0 generates from TFTP server running
on the development workstation to the SDRAM on the SBC6300X main board
via Ethernet cable, then the file will be converted into NK.nb0 before being
burnt to NAND flash. The TFTP server mentioned here can be the server
provided in VS2005 WinCE 6.0 development environment or other TFTP
servers. Please note that the port parameter of the TFTP server that you use
is 980 instead of 69, the standard TFTP port. The software CEDownload.exe,
which we will describe in Section 3.4 below is a TFTP server software, which
has changed the default TFTP port from 69 into 980.
3.2 Booting from DataFlash
3.2.1 Install the SAM-BA software
Install the AT91-ISP v1.12.exe application (located in \03 WinCE 6.0
Kit\04 Tools\) on the SBC6300X CD to your development workstation