Specifications

Page | 44
 Copy the all the files from the directory: disk/linux/image to the SD
card.
 Depending on your display device LCD (4.3” or 7”) or VGA, rename
“uImage_xx” as uImage
Update the image
1. Enter u-boot
Insert the SD card into the SOC8200 board, and make sure you have
connected the jumper cap on J24 (see Figure 10)
Note:
 Regardless of whether you are updating the image for the SD card or NAND
Flash, you must start the image from the SD card.
Figure 10: J24 Location
J24