Specifications

Page | 34
flash-uboot.bin uImage
4. Umount the USB-host.
[root@OMAP3EVM /]# umount /mn
4.3.7 Network Test
The board has a 10/100M self-adapting network card (DM9000); users can
connect the board to the LAN and enter the following commands to test:
[root@OMAP3EVM /]# ifconfig eth0 192.192.192.201
eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffffff:00, id=7c0f1)
[root@OMAP3EVM /]# PHY: ffffffff:00 - Link is Up - 100/Full
[root@OMAP3EVM /]# ping 192.192.192.90
PING 192.192.192.90 (192.192.192.90): 56 data bytes
64 bytes from 192.192.192.90: seq=0 ttl=128 time=5.005 ms
64 bytes from 192.192.192.90: seq=1 ttl=128 time=0.396 ms
64 bytes from 192.192.192.90: seq=2 ttl=128 time=0.305 ms
64 bytes from 192.192.192.90: seq=3 ttl=128 time=0.305 ms
64 bytes from 192.192.192.90: seq=4 ttl=128 time=0.305 ms
Note:
 The IP address shown above is an example, it can be changed if required
 Press ctrl+c to quit.
4.3.8 Camera Test
Connect the camera module and the CCD camera well, execute the following
commands to test after entering the system.
[root@OMAP3EVM /mnt]# saMmapLoopback
Capture: Opened Channel
Capture: Current Input: Composite
Capture: Input changed to: Composite
Capture: Current standard: NTSCvpfe-capture vpfe-capture: width = 720, height
= 480, bpp = 2
vpfe-capture vpfe-capture: adjusted width = 720, height = 480, bpp = 2,
bytesperline = 1440, sizeimage = 691200
Capture: Number of requested buffers = 2
Capture: Init done successfully