Specifications

Page | 31
mmcblk1: mmc0:0001 000000 122 MiB
mmcblk1: p1
2. Mount the MMC/SD card to directory /mnt:
[root@OMAP3EVM /]# mount -t vfat /dev/mmcblk1p1 /mnt/
[root@OMAP3EVM /]# ls /mnt MLO u-boot.bin ubi.img
flash-uboot.bin uImage x-load.bin.ift_for_NAND
3. Umount the SD card:
[root@OMAP3EVM /]# umount /mnt
4.3.5 USB OTG Test
Use the SOC8200 as a DEVICE and the USB OTG as a slave：
1. The user can connect the development board and the pc via a
USB mini B to USB A cable after the system runs.
Note:
 Install the Linux USB Ethernet/RNDIS Gadget driver according to 5Appendix
1:Driver Installation Of Linux USB Ethernet/RNDIS Gadget.
2. After successful connection, the PC will show a virtual network
card as displayed in below figure：
Figure 7: Virtual Network
3. Set the IP address of the virtual network card, for example: