Specifications

Page | 28
NAND Flash without connecting the jumper cap. If you do not wish to use
VGA, please refer to: Update the image in the NAND Flash on p46.
SD card Boot
If you need to boot from the SD card, please refer to the following section
4.2.4 Display Options
To enable display on LCDs (4.3”, 7”, 10.4”) or VGA, use the instructions
below:
1. Replace the SD card uImage file
Copy the required image to the SD card and delete the previous uImage.
Rename the “uImage_xx” to “uImage” on the SD card.
Warning：
 The XX’’LCD is the size of LCD you are using, is the options included are: 4.3”,
7”, 10.4”, and VGA).
2. Enter U-boot Shell
40X
Texas Instruments X-Loader 1.45 (Mar 19 2010 - 16:09:58)
Starting X-loader on MMC
Reading boot sector
213544 Bytes Read from MMC
Starting OS Bootloader from MMC...
Starting OS Bootloader...
U-Boot 2009.11-svn ( 3 19 2010 - 16:14:31)
OMAP34xx/35xx-GP ES1.0, CPU-OPP2 L3-165MHz
AM3517EVM Board + LPDDR/NAND
I2C: ready
DRAM: 256 MB
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Die ID #796400000000000001543b2106011005