Installation guide

9
We recommend connecting any Home Theatre Media Centre
Computers or appliances containing a hard drive into the
‘Always On’ socket to prevent accidental removal of power
during power cycles. This will prevent damage to, and extend
the life of your Home Theatre Projection lamps.
The Embertec SmartSwitch™ AV
(M)
has 2 power
saving functions
1. Standby Powerdown automatically detects and switches
o wasted Standby Power when the equipment is left in
standby mode.
2. Active Powerdown automatically switches the power o to
Audio Visual (AV) equipment connected to the power saver
socket after 1 hour, if it has not detected any remote control use.
NOTE: The Embertec SmartSwitch™ AV
(M)
is programmable and has an
Active Powerdown default setting of 1 hour, which can be permanently
set to 2 or 3 hours, or temporarily 8 hours (MusicMode
™).
When will Active Powerdown Switch the Audio
Visual (AV) Equipment o?
• If your Embertec SmartSwitch™ AV
(M)
detects that your Audio
Visual (AV) equipment is on but has not been used for a
period of 1, 2, 3 or 8 hours (depending on your settings),
the LED light on the SmartSensor will ash for approximately
10 minutes to warn you that power down is imminent.
To continue using your equipment.
• Simply press ANY button on ANY of your existing remote
controls or press the button on the SmartSensor once. This
will cancel the Active Powerdown and reset the timer to its
setting of 1, 2, 3 or 8 hours (according to your setting).
NOTE: A ashing LED always means that your system will shut down
completely in a while. Press any remote control button to stop the
light ashing and continue using your system.