Installation guide

16
Problem To Check
The Embertec SmartSwitch™
AV
(M)
is not receiving power.
The Embertec SmartSwitch™
AV
(M)
is not powering down
my equipment in standby
mode.
The SmartSensor ashes
frequently during normal
operation.
• Ensure the mains power supply
switch is turned on at the wall or
powerboard.
• Ensure the equipment is plugged
into the Power Saver socket, not into
the ‘Always On’ socket.
• The Embertec SmartSwitch™ AV
(M)
has not detected the equipment
is in standby. Please repeat this
process by switching on the Audio
Visual (AV) component again,
waiting 10 seconds, and switching
o again making sure all appliances
are in standby mode.
• This may be an indication of
unwanted infrared activity in the
area. Please check the immediate
area for infrared devices that maybe
interfering with the Embertec
SmartSwitch™ AV
(M)
(such as compact
uorescent lights, computers,
mobile phones, and other portable
consumer electronic devices) and:
• Move the SmartSensor to another
location that is within line of sight
and normal operation of your
Audio Visual (AV) equipment
remote controls.
Troubleshooting Guide