Installation guide

12
To set the Active
Powerdown
timer to:
Press the button
on the
SmartSensor:
To conrm the
setting, the LED light
on the SmartSensor
will ash:
Once, then release1 hour
(default setting) 1 time
Please make sure the sensor has ashed back 1, 2 or 3 times
1. Ensure your Audio Visual (AV) equipment is switched on.
2. Press and hold down the button on the SmartSensor
rmly for 3 seconds, then release. The LED light on the
SmartSensor will ash for a few seconds as it enters
Settings Mode.
3. As soon as the LED light on the SmartSensor has stopped
ashing, immediately begin to set the Active Powerdown
to 2 or 3 hours, by pressing and releasing the SmartSensor
button, as per the table below.
Twice2 hours 2 times
Three Times3 hours 3 times
Changing settings for Active Powerdown using
the SmartSensor
Your Embertec SmartSwitch™ is equipped with a number of
settings to suit your lifestyle. You can set your timer to either
1, 2 or 3 hours, depending on usage habits. This means the
SmartSensor will ash after the set period, warning of imminent
power down. In every case you can continue using your
equipment by pressing any button on any remote control.
The default setting is 1 hour, which is aimed to maximise your
energy savings.
To change Active Powerdown to 2 or 3 hours, (this may be
appropriate for longer movies or programs where remote
control activity is unlikely).