Installation guide

11
Turning ON your AV Equipment
• To operate your Audio Visual (AV) components, press any
button on any existing remote control(s), or press the button
on the SmartSensor. This will apply power to all components
and place them in standby mode, ready for use. You can
continue using your existing remote(s) to operate your
television or other Audio Visual (AV) components in the
normal way.
NOTE: To reactivate your TV components, you may be required to
press the power button again on the relevant remote after power
has been restored.
Turning OFF your AV Equipment
• Simply turn your equipment o in the normal way. Once the
Audio Visual (AV) components have been switched o, the
Embertec SmartSwitch™ AV
(M)
will remove power from the
Power Saver socket after a delay of approximately 1 minute.
NOTE: The LED light on the SmartSensor will ash for about 60
seconds to warn you that power is about to be removed from the
AV power saver outlet.
SmartSensor
The infrared SmartSensor activates the Power Saver socket,
monitors activity and is used to set the Active Powerdown
timer. The SmartSensor receives signals from any of your remote
controls and recognises when you are interacting with your
Audio Visual (AV) components. SmartSensor default setting for
Active Powerdown is 60 minutes.