Installation Guide

3
5. You must operate this log set with fireplace
in place and fully closed. Unless provided by other
means, fireplace doors or screens shall haveopen-
ings for introduction of combustion air.
6. This log set is designed to be smokeless. If logs
ever appear to smoke, turn off appliance and call a
qualified service person.
Note: During initial operation, slight smoking could
occurduetologcuringandtheburning off of man-
ufacturing residues. You may wish to add more
ventilation by opening a window.
7.
To reduce the creation of soot, follow the “Cleaning
and Maintenance” instructions on
,
page 13.
8. Do not allow fans to blow directly into the fireplace.
Avoid any drafts that alter burner flamepatterns. Ceiling
fanscancreated
rafts that alter burner flame patterns.
Altered burner patterns can increase sooting.
Continued
9. Do not use a blower insert, heat insert or
other accessory not approved for use with this log
set.
-exchanger
10.
Theinstallation andprovisionsforcombustion and vent-
ilation air must conform withthe National Fuel Gas
Codes, ANSI Z233.1/NFPA 54, Air for Combustion and
Ventilation.
11. Do not run log set:
•
where combustible materials, gasoline and other
flammable vapors and liquids are used or stored
• under dusty conditions
12. Do notburn solidfuelinthefireplaceafterinstalling the log
set. Donot use this log set to cook food or burn paper or
other objects.
13. Log set becomesveryhotwhenin use.Keep childrenand
adults away from hotsurface to avoid burns or clothing
ignition. Log set will remain hot for a time after shut-do
wn.
Allow surface to cool before touching.
14. Carefully supervise young children when they are in
the room with log set.
15. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
16. To help prevent breakage, new logs must be broken-in
(see
“Curing Logs”page 12).
17. Turn log set off and let cool before servicing, installing,
or repairing. Only a qualified service person should in-
stall, service,or repair log set.
18. Provide adequate clearances around air openings.
PRODUCT IDENTIFICATION
Figure 1 - Product Identification - VMO24RNGA Shown
SAFETY
screens
Burner Tube
Heat Shield
Control Knob
Burner Pan