Use and Care Manual

www.sureheat.com
35200084-01A
Continue with replace installation, returning to
Connecting to Gas Supply , page 13.
MANTEL
12. After assembling the mantel, carefully lift
to the upright position. Push the replace
insert from the front of the mantel as
shown in Figure 39.
Figure 39
Fireplace Insert
13. Drill two holes (5/16") in the corner where
the replace is to be displayed. Drill the
rst hole 37
7
/
8
" from the ground up. Drill
the second hole 1
9
/
16
" from the rst hole as
shown in Figure 40. Place 2) Wall Anchors
(CC) into holes by pinching the anchor tabs
together as shown in Figure 40.
41
1
/
2
"
1
9
/
16
"
Figure 40
CC
Mitered Corner Joints
37
7
/
8
"
14. Install the Set Square Support (H) to
the holes drilled in step 13, with 2) ST5
Screws 2
3
/
8
" (EE) as shown in Figure
41. This block is used to support the Top
Triangle Panel (F). For thin walls, insert
white key (HH) into wall anchor and push
to “pop” open anchor wings.
31
1
/
2
"
Figure 41
Mitered
Corner
Joints
Baseboard
30
3
/
4
"
HH
EE
H
15. Push replace into the corner so that the
Top Triangle Panel (F) is resting on top of
the Set Square Support (H) as shown in
Figure 42.
Figure 42
H
F